Troubleshoot and Maintenance
•
•
•
•
•
•
•
Configure Syslog Reports
Debug information can be configured from the administration section of the Cisco Unified Communications
Manager. Refer to the Product-Specific Configuration Parameters for information about configuring debug
parameters. Note the following when configuring debug parameters from the Cisco Unified Communications
Manager:
• Log Server / IPv6 Log Server: Syslog server in IPv4 and IPv6 format
• Remote Log: Enabled or Disabled. Log messages are not sent to server if set to Disabled.
• Log Profiles: Debug flag settings of log modules.
The Log Module, the Log Setting, and the Log Viewer can be generated from the administration section of
the phone web page. Note the following:
• Log Module: To configure debug flags; these parameters are overwritten by the Unified Communications
• Log Setting: To configure log server, port and size. Server settings are overwritten after provisioning.
• Log Viewer: To view, clear or download debug messages being logged.
Because debugging captures detailed information, the communication traffic can slow down the phone, making
it less responsive. After you capture the logs, turn off debugging.
Manager Log Profile unless Preset is selected.
Cisco ATA 191 Analog Telephone Adapter Administration Guide for Cisco Unified Communications Manager
6
C H A P T E R
41