Tone Configuration - Cisco ATA 191 Administration Manual

Analog telephone adapter
Hide thumbs Also See for ATA 191:
Table of Contents

Advertisement

Tone Configuration

Tone Configuration
• Only the ATA 191 Line1 network locale setting is applied. The line2 network locale always applies the
• Only these tones can be configured:
Any tone specification that appears in the tone profile but is not supported or has invalid data fields (even if
the tone is supported) is ignored.
• Example: A tone profile includes a valid reorder tone specification, an invalid busy tone specification
• The name of the XML file that describes tones and cadences is g3-tones.xml.
• Each tone can specify at most four c/i pairs (about frequency and gain) and four cadence segments (each
Cisco ATA 191 Analog Telephone Adapter Administration Guide for Cisco Unified Communications Manager
66
line1 option, even if the configured value of line2 network locale differs from the line1 value.
◦ Ringback tone
◦ Reorder tone
◦ Dialing tone
◦ Outside dialing tone
◦ Busy tone
◦ Call waiting tone
(has invalid data fields), and a recording tone spec (not supported). Only the reorder tone spec would
be applied.
is an on/off pair). Any additional data gets discarded.
ATA 191 Country-Specific Tones and Cadences

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents