Ethernet Led; Satellite Tracking (Stat) Led - Topcon MR-2 Operator's Manual

Ethernet LED

The Ethernet LED indicates the status of the Ethernet connection.

Satellite Tracking (STAT) LED

There are two LEDs to indicate the status of satellite tracking. If your receiver has only one B125 board, only
the STAT LED for the primary antenna will operate (Figure 4 on page 10). If your receiver has a second B125
board will both STAT LEDs operate. The number of blinks the LED makes indicates the number of satellites for
that constellation. Table 5 describes the blink patterns.
Blink Order
1 Green blink per tracked GPS satellite
2 Dark once
3 Yellow blink per tracked GLONASS satellite
4 Dark once
5 Cyan blink per tracked Galileo satellite
6 Dark once
7 Magenta blink per tracked Compass satellite
8 Dark once
9 Blue blink for each QZSS satellite
10 • One red blink: Receiver is not tracking satellites or does
• Dark: Receiver has a valid position solution
Receiver Status LEDs
Table 4. Ethernet LED Patterns
Display
Solid Red: No Ethernet connection.
Solid Green: Ethernet Connection
established.
Table 5. STAT LED
Definition
not have a valid position solution
Description
P/N: 1011907-01 11