Led Description; Led Display Panel - Topcon HiPer VR Quick Reference Card

Charging the internal battery
1. Connect the supplied power cable to the receiver's power port.
2. Connect the SAE connector of the power cable to the SAE connector of the
power adapter.
3. Plug the power adapter into an available outlet for approximately five hours to
fully charge the battery.
POWER BUTTON FUNCTIONS
FUNCTION
Power On
Power Off
Start/Stop Data
Logging
Toggling between
Static and Kinematic
post-processing
modes
Performing factory
reset
Emergency Power
Off

LED Display Panel

LED ICON KEY
SOLID
A power input greater than 27 VDC could damage the
receiver.
PRESS
BUTTON
1+ seconds
3-10 seconds
Press three
times in a
row within 2
seconds
Press three
times in a
row within 1
second
10-15
seconds
60 seconds
A delay of several seconds occurs between the last clicking
of the Power button and first blinking/last blinking of the
REC LED.
When using external power, the Power LED is solid green
except for startup and shutdown procedures.
BLINKING

LED DESCRIPTION

Power LED blinks until startup completes.
After that the LED light is solid green, if
the external power source is connected to
the receiver. If the external power source
is not connected to the receiver, the LED
is off.
Release the Power button when the STAT
LED turns yellow.
Refer to the REC (Recording) LED
description.
Refer to the REC (Recording) LED
description.
This function is available for "Occupation
mode switch" only. See Topcon Receiver
Utility (TRU) Help.
Release Power button when STAT LED
blinks magenta.
Release the Power button when all of the
LEDs are off.
OFF