Function Button; Receiver Status Leds; Tracking Status Led - Topcon Net-G5 Operator's Manual

Function Button

FUNCTION
Power Off
Start/Stop Data
Logging
Toggle Post-
Processing Mode
Change Information
Mode
Change Baud Rate of
Serial Port

Receiver Status LEDs

The status LEDs provide information about the battery life, tracked satellites, memory capacity, and wireless
connectivity. This section describes the color and behavior of each LED.

Tracking Status LED

The tracking status LED displays what type of satellite the receiver is tracking.
Table 6. Tracked Satellites
Color
Green GPS
Yellow GLONASS
Cyan Galileo
Blue SBAS/OMNI
Magenta BeiDou
White QZSS
Function Button
Table 5. Function Button Features
PRESS BUTTON
Press button
1-5 seconds
Less than 1 second
Three times for less
than 3 seconds
5-8 seconds
Description
LED DESCRIPTION
RECEIVER IS OFF
No action.
RECEIVER IS ON
• REC LED is green indicating data logging has started.
• REC LED blinks green each time data is written to the receiver's
memory.
• REC LED is red when receiver is out of memory, has a hardware
problem, of contains an improper OAF.
• Press for less than 1 second when "Occupation mode switch"
has been enabled using TRU.
• Press three times for less than 3 seconds when "LED blink mode
switch" has been enabled using TRU.
• After approximately 5 seconds, the REC LED becomes red.
Release the Function button during the next 3 seconds.
P/N: 1004636-01 10