Operating Instructions; Wall Control - Seeley Climate Wizard CW-H10 Installation & Operation Manual

OPERATING INSTRUCTIONS

WALL CONTROL

TURNING THE COOLER ON
The wall control can be switched on and off by pressing the
button. The wall control will remember the previous setting
it was in when the cooler was last used.
PREPARING TO START
Whenever you select AUTO mode or COOL in MANUAL mode,
the cooler will take a few minutes to start as it fills with water
and saturates the cooling cores. The time will be decreased if
the reservoir is full or the cooler has only recently been turned
OFF.
MANUAL MODE
With the wall control switched ON, press the
MAN is shown on the display.
(Note! The Wall control display will default to show temperature
in °C (Celcius). If °F (Fahrenheit) are desired, refer to Page
23 for instructions on how to change the A8 Temperature Unit
parameter.
Man
Cool
You may then press the
and VENT. (VENT = fresh air being delivered but not cooled).
Once COOL or VENT has been selected, the wall control will
maintain a constant fan speed. This is indicated by the bar
graph shown on the display.
Man
Cool
ILL1707-A
To increase or decrease the fan speed required, press either
ILL1707-A
the or button.
AUTO MODE
To select the AUTO mode press the
shown on the display.
In AUTO mode the cooler will remember the last setting
used and try to achieve this. It may vary depending on the
day's conditions. Pressing
the displayed 'room' temperature to a flashing 'setpoint'
temperature. This 'setpoint' temperature can be adjusted
by pressing the or
temperature is being displayed.
Auto
Cool
26 |
CW-H10, H15, H15S, H15S Plus
button until
F
ILL1709-A
button to switch between COOL
ILL1709-A
Man
Vent
ILL1708-A
button until AUTO is
or button will change
buttons whilst the 'setpoint"
ILL1710-A
ILL1710-A
DELAYED START AND STOP
The cooler can be programmed to start at a specific time or stop
at a specific time.
The delayed start time can only be programmed when the
cooler is OFF. To program the cooler to Start in a certain
amount of hours use the following sequence:
Programming in manual mode
1. Press the button.
2. Press the button until "MAN" is displayed on the
screen.
3. Press the or
displayed by the bars in the middle of the screen.
4. Press the button to set either COOL or VENT.
5. Press the button and the 'starts in' time will start
flashing. Use the
time.
6. Press again.
Programming in auto mode
1. Press the button.
2. Press the button until flashing AUTO and set
temperature are displayed. Press the
until the desired temperature is displayed on the screen.
3. Press the button and the 'starts in' time will start
flashing. Use the
4. Press again.
The delayed stop time can only be programmed when the
cooler is ON. To program the delayed time in which you want
the cooler to stop use the following sequence:
Select the button and the 'stops in' time will start flashing.
Use the and
ILL1708-A
1. Press again.
Note! Delayed start and stop times must be re-set every day
that they are required.
button until the desired fan speed is
and buttons to select the desired
Man
Cool
Starts in
hrs
ILL1711-A
ILL1711-A
or
or button to select the hour.
buttons to select the desired off time.
ILL1119-B
button