Inlet Air Filter Assembly Or Safety Grille - Seeley Climate Wizard CW-H10 Installation & Operation Manual

INSTALLATION cont.

INLET AIR FILTER ASSEMBLY OR SAFETY GRILLE

Climate Wizard coolers SHOULD NEVER BE INSTALLED
WITHOUT DUST FILTERS.
Use either the Inlet Air Filter Assembly supplied from the factory
or use the cooler with pre-filtered air to EN779 G4 or ASHRAE
52.2 MERV8 standards.
Should the Inlet Air Filter Assembly not be required an Inlet Air
Safety Grille is available and MUST be fitted for safety reasons.
Other Safety Grilles cannot be substituted.
The Inlet Air Filter Assembly or Safety Grille is supplied in
separate cartons when shipped with the Climate Wizard.
OPTION 1 – INLET AIR SAFETY GRILLE (FOR USE WITH
PRE-FILTERED AIR ONLY)
CW-H10, CW-H15, H15S, H15S Plus: = P/N 120102
ILL2433-A
ILL2433-A
12 |
CW-H10, H15, H15S, H15S Plus
Fit the Inlet Air Safety Grille
using the 4 x M6 X 16MM SET
SCREWS AND WASHERS pre-
fitted to the inside surfaces of
the air inlet recess.
ILL2434-A
ILL2434-A
OPTION 2 - INLET AIR FILTER ASSEMBLY
CW-H10: = P/N 120409
CW-H15, H15S, H15S Plus: = P/N 120379
1. Remove the air filters from their shipping position in the
frame.
2. Fit the Inlet Air Filter Assembly using the 4 x M6 x 16mm Set
Screws and Washers pre-fitted to the front face of the air
inlet recess. Ensure the frame is centred around the fan inlet
cone.
CW-H10
ILL2436-A
ILL2436-A
3. Re-fit the air filters, ensuring the sticker showing direction of
air flow is the correct way round.
CW-H15, H15S, H15S Plus
ILL2437-A
ILL2437-A
ILL2435-A
ILL2435-A