Inlet Air Filter Cowling Assembly - Seeley Climate Wizard CW-H10 Installation & Operation Manual

INSTALLATION cont.

INLET AIR FILTER COWLING ASSEMBLY

Climate Wizard coolers installed outside should be fitted with an
inlet air cowling assembly to protect the air filters from exposure
to water. It features a detachable front panel for easy access to
the filters.
The Inlet Air Cowling Assembly is supplied in a separate carton
when shipped with the Climate Wizard. It contains a small bag
of fasteners required for fitment to the cooler.
CW-H10: = P/N 120416
CW-H15, H15S, H15S Plus: = P/N 120386
1. Fit the 2 x Cowling Side Panels. Ensure the black plastic
fitting is at the bottom of the panel.
a. CW-H15, H15S, H15S Plus: – Screw the cowling side
panels to the cooler using the supplied 6 x SCREW SEMS
HEX 14 x 3/4" ZP into the pre-fitted plastic grommets fitted
to the cooler body.
b. CW-H10 – Fit the right hand side panel as above.
Fit the left hand side panel using the same pre-fitted M6 x
16mm Set Screws and Washers used to fit the filter frame to
the cooler.
2. Fit the supplied 6 x PLASTIC GROMMET SIZE 14 to the
sides of the Cowling Top Panel
3. Remove the pre-fitted centre and right hand screws from
the cooler lid back panel. Slip the long large upstand of the
Cowling Top Panel under the lip of the cooler lid back panel
and re-fit the screws.
4. Screw the cowling side panel and the top panel to the cooler
body with supplied 6 x SCREW SEMS HEX 14 x 3/4" ZP.
5. Fit the supplied 2 x quarter-turn, self-ejecting fasteners to
the Cowling Front Panel. Ensure the supplied split washer is
fitted as shown.
6. Rest the return fold of the cowling front panel on the lip of
the top panel. Secure the bottom corners using the quarter-
turn self-ejecting fasteners.
ILL2438-A
ILL2438-A
ILL2439-A
ILL2439-A
ILL2440-A
ILL2441-A
SEELEY INTERNATIONAL - INSTALLATION MANUAL |
ILL2440-A
ILL2441-A
13