Power Connector Cable - HP OMEN 15-ce100 Maintenance And Service Manual

Power connector cable

Description
For use only on computer models equipped with the Nvidia N17P GPUs
For use only on computer models equipped with the Nvidia N17E GPU
IMPORTANT:
and replacement
Before removing the power connector cable, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Hinge covers (see
b. System support brackets (see
Remove the power connector cable:
1. Disconnect the power connector cable from the system board (1).
2. Remove the power connector cable (2).
Reverse this procedure to install the power connector cable.
48 Chapter 6 Removal and replacement procedures for authorized service provider parts
Make special note of each screw and screw lock size and location during removal
Battery on page
Hinge covers on page
36), and then remove the following components:
45).
System support brackets on page
Spare part number
926204-001
938137-001
46).