Table of Contents
Advertisement
20221867 / F
COP20 Operator panel (Option)
COP20 should be located where it is most convenient for the
user, with special regard to the user's need for easy operation.
Refer standard and optional cable length for cables between
operating panels and MC50 unit, page 29.
It is recommended that adequate ventilation/air-conditioning is
provided in order to keep the ambient operating temperature at
+20°C.
Use the following procedure when installing the COP20:
1
Cut a hole where COP20 is to be fitted. Refer
dimensional drawing on page 43, and the cut-out
template on page 47.
2
Lift the four removable corners from the panel.
3
Locate COP20 in the hole, and secure the unit to
the panel with four 4mm screws.
4
Reposition the removable corners on the panel.
COP10 Remote Operator panel (Option)
COP10 is designed to be mounted in the helmsman chair's
armrest.
1
Cut the necessary holes in the armrest where COP10 is to
be fitted. Refer COP10 dimensional drawing on page 42,
and the cut-out template on page 45.
2
Secure the unit to the panel with the nut as shown on the
figure.
Monitor
Refer to separate documentation delivered with the monitor for
installation procedures.
INSTALLATION
5
Advertisement
Table of Contents
