Table of Contents
Advertisement
Note!
24V DC SUPPLY
20221867 / F
24V DC
If the CS66 system is to be supplied with 24V DC, the power
should be connected via the FB200 Filter box.
Do not connect 24V without using this filter box. Doing so may
course electromagnetic interference!
1
Remove the cover on the FB200, and connect the cable
from 24V DC supply according to the labelling on the
terminals as shown on the figure below.
This cable is not supplied with the equipment! It should have a
cross section of at least 2.5mm
GND
FROM
2
Connect the cable from FB200 to the 24V DC power-in
jack on the MC50.
3
Secure the cable to the fixing bracket to avoid that
vibration should cause the plug to loose connection.
2
(gauge).
+
-
INSTALLATION
TO
MC50 24V DC
POWER-IN
TERMINALS
7
Advertisement
Table of Contents
