ACeS OG698 Phone User's Guide
Set the Minute Minder
This function indicates the time spent during conversation by entering a short
beep every minute.
To set the Minute Minder:
›
$
1
Select Min minder from the SETTINGS
SETTINGS @
menu
¯
˘
Min minder
2
Choose between On and Off using the navi-
(On)
gation key
3
Press YES to confirm your selection.
Change the Display Backlight
The display light can be set to automatic, turned off or turned on.
In automatic mode, the display light is turned off automatically 10 seconds
after the last key has been pressed. It will be turned on again when a key is
pressed or when a call or message is received.
To set the display light:
›
$
1
Select Light from the SETTINGS menu
SETTINGS@
2
Choose the desired display light setting using
¯
˘
Light
the navigation key
Auto
3
Confirm your selection by pressing YES
Page 34
You can have one setting when the phone is used as a handheld unit and
another setting when the phone is used with a handsfree kit, powered from an
external source.
If you place the phone in a vehicle handsfree cradle and make a selection, the
setting will only apply to handsfree mode. You can set the display light to be
turned on always in handsfree mode and still have it in automatic mode other-
wise.
Set the Ring Signal Level
To change the volume of the ring;
›
RING LEVEL
¯
0øøøøøØ¨
›
RING LEVEL
0øøøøøØ¨
¯
4
Press YES. The message Stored displays.
Tip! Use the side keys to change the ring level silently.
If your phone is connected to handsfree equipment, the ring signal level is set
separately. See "Handsfree Calling" on page 52 for more information.
Note: Some features and menus are operator dependent
1
From the SETTINGS menu, select Ring
#
level
2
Press YES. The ring level indicator displays.
˘
3
Press the navigation key to set the ring signal
#
level. The phone will ring once as you increase
the tone level
External
˘
Press the left key to decrease the volume
Press the right key to increase the volume
Version P1C
Need help?
Do you have a question about the ACeS OG698 and is the answer not in the manual?