Set Clock; Set Satellite Antenna Pointing - Ericsson ACeS OG698 User Manual

ACeS OG698 Phone User's Guide

Set Clock

Your phone displays the time when in standby mode. During a call, it displays
the time elapsed since the call began. You can also set other clock-related
functions such as date, time and date format and the alarm. See "Time and
Date" on page 29.
¤ fl @
To set the time:
CLOCK
1 From the TOOLS\Clock menu select Set
¯ ˘
(Set clock)
clock
[08:35]
2 Enter the time in hours and minutes
If Clock/Clockmode is set to AM/PM, you can
switch between AM and PM by pressing * or #.
3 Press YES

Set Satellite Antenna Pointing

When the satellite signal is not strong enough for the phone to receive calls or
register with the network, the Antenna Pointing feature can sound a signal that
will assist you with positioning the antenna when receiving a call. See "Point
Antenna" on page 17.
To activate the antenna pointing feature:
1 Scroll to display SETTINGS\Point antenna\ON
2 Press YES to enable the feature
To deactivate the Antenna Pointing feature:
1 Scroll to display SETTINGS\Point antenna\OFF
Page 14
2 Press YES
If set to ON, you will hear the satellite assist signal consisting of different
pitches (depending on the signal strength) when receiving notification of a
pending call. The signal will continue until time-out or a full satellite signal
is acquired, or until you press CLR to turn it off.
If set to OFF, instead of the signal described above, the call pending notifi-
cation signal of three short tones is repeated every 5 seconds until timeout
or your phone locks onto a signal that is strong enough for your phone to
respond to it
‹
SAT pointing
¯
Note: Some features and menus are operator dependent
Ø @ If set to ON, you will see the display shown at
the left when antenna pointing assistance is
needed.
˘
On
The volume for the Antenna Pointing signal is the
same as the ring volume. To change the setting
see "Set the Ring Signal Level" on page 34.
Version P1C