Sunny Health & Fitness Obsidian Surge 500 User Manual page 8

# 58 M8*15 4pcs
# 60 M8*15 4pcs
# 71 OD20*ID8.5*1.5 4pcs
# 74 S5
36
60 71
60
71
#71 OD20*ID8.5*1.5 4pcs
71
5
#74
1
#56 M8 1pc
#63 M8*70 1pc
#71 OD20*ID8.5*1.5 2pcs
#74 S5
#75 S13-17
ASSEMBLY INSTRUCTIONS
3
60
71
58
58
1
#60 M8*15 4pcs
S5
46
47
63 71
56
71
5
8
STEP 4:
NOTE: Move the Seat (No. 36) to the front of the
Slide Rail (No. 3) before assembly to prevent it
from gliding down during assembly.
Attach the Slide Rail (No. 3) to the Main Frame
(No. 1) using 4 Washers (No. 71), 4 Screws (No.
60) and 4 Flat Screws (No. 58). Insert all 8
screws partially into the holes first, and then
tighten with Allen Wrench (No. 74).
STEP 5:
Attach Sensor Stand (No. 5) to Main Frame (No.
1) using 4 Washers (No. 71) and 4 Screws (No.
60). Tighten with Allen wrench (No. 74).
If you are sitting on the Seat, the arrow sticker on
the Sensor Stand (No. 5) must be pointing
towards you. That means the Sensor Stand (No.
5) is installed in the correct direction.
STEP 6:
Connect 2 Sensor Wires (No. 47) with the wires
of the Meter (No. 46)
Attach the Meter (No. 46) to the Sensor Stand
(No. 5) using 1 Screw (No. 63), 2 Washers (No.
71) and 1 Nylon Lock Nut (No. 56). Tighten with
Allen Wrench (No. 74) and Spanner (No. 75).
Make sure it is not too tight to adjust the angle of
Meter (No. 46).
The assembly is complete!
.