Table of Contents
Advertisement
18.7.99
Switching off the handset
Signaling method
Checking the signaling method of your telephone line
Setting the signaling method
. t Service
@ 3 3 x
u
REDIAL
@37 x
u
REDIAL
KAP04.FM5
When the handset is switched off:
h
Press the handset key briefly. You will hear the positive
confirmation beep. The display flashes. Wait until it stops
flashing. The handset is switched on.
or
Place the handset back into the base station. The mes-
sage appears on the display. The handset is switched on.
h
Press the handset key until the display message is
cleared. You will hear the positive confirmation beep.
The PTT operates telephone connections with two differ-
ent signaling methods:
Dial pulsing (DP)
Dual-tone multifrequency signaling (DTMF)
The factory default setting for your Gigaset 2011 Tango is
DTMF .
c
Press the off-hook key. You will hear the dial tone.
Press any digit, e.g. 2. If you still hear the same dial tone,
o
you must switch the signaling method to dial pulsing
(DP).
t means: browse using x
(
Call up the "Service" menu item.
#1
Start the setting procedure
Enter the four-digit base code (factory default: "0000")
o
(
page 7).
Set to dial pulsing (DP).
SET
or
Set to DTMF . A flash time of 100ms is set.
SET
Gigaset 2011 Tango: A30852-X1106-B307-2-7619
Operating modes
confirm using u
Z
,
)
OK
7
Advertisement
Table of Contents
