Da-Lite Tensioned Advantage Deluxe Electrol Instruction Book page 8

Tensioned Advantage
120V Wiring Diagram
NOTE: Electrical connections on
left end of case.
Use provided knockouts for all
electrical connections. DO NOT
drill additional holes into screen
case or end cap.
NOTE: 20-24AWG Wire Recommended
For Connecting Wall Switch to the Dual
Motor Controller
White (Common)
Power Input
Black (Hot)
120VAC / 60HZ
Green (Ground)
Communication Instructions
The connection settings for the SCB-100 are 9600 Baud Rate, 8 Data Bits, None Parity, 1 stop bit and XON/XOFF Flow Control. The
control is NOT Bi-Directional, but it will give a response to commands sent.
1. When the SCB-100 unit first powers on it will send back the
(Version, X-on). The LED on the SCB-100 unit will flash green,
red, green and red.
2. To send the screen down the command is "*1c04;"
8
Deluxe Electrol Instructions Optional SCB-100 Control
® ®
To Third Party
Control System
Front of Back of
Wall Switch Wall Switch
UP
W B R
STOP
DOWN
White (Common)
Not Used
Black (Hot)
RJ-14 to DB-9
Connector
6P4C
RJ-14
(25 ft. Cable)
RJ-14 Must Be
Plugged Into
SYS 1 Main
SYS7
Red (Up)
SYS1
Black (Down)
Not Used
AUX EYE
White (Common)
3. To send a stop command to the screen is "*1s04;"
4. To send the screen up the command is "*1o04;"
5. The unit will respond with a "LF" if command was good. It will
respond with "U" if the command was not understood.
LED
RS-232
9600 8 N 1
SYS6 SYS5 SYS4
SYS2 SYS3 RS-232
6P6C
RJ-22
(6 in. Cable)
White (Common)
Red (Up)
Black (Down)
Black (Down)
Red (Up)
White (Common)
Red (Down)
Black (Up)
White (Common)
White (Common)
Red (Down)
Green (Ground)
Not Used
Door Microswitch
RS-232 9600 8 N 1
White (Common)
Red (Up)
Black (Down)
Green (Ground) Green (Ground)
Screen Motor
White (Common)
Red (Down)
Black (Up)
Black (Up)
Green (Ground)
Door Motor