4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized service dealer when repair Da-Lite® is a registered trademark of Milestone AV Technologies. work is required. Incorrect reassembly can cause electric All rights reserved.
Pre-Installation Case Installation 1. Carefully unpack screen and remove outer wrapping 1. The case provides multiple attachment points for bolts, from case. cables, or threaded rod. Page 7 shows threaded rod installed. The variable position-mounting bracket may be located 2. Make sure to recheck measurements of screen location anywhere along the length of the case.
Page 4
Screen And Roller Assembly Installation If your screen was shipped with the motor and roller already installed proceed to step 6. 7. Test installation by operating the screen several times. Be 1. Remove the screw from each end of the access door (front door) and open the door.
5 cm (2 po). Consultez la fiche technique pour plus de renseignements. CAUTION: Contact Da-Lite at 800-622-3737 or 574-267-8101 if door motor needs adjustment. ATTENTION: Contactez Da-Lite au 800-622-3737 ou au 574-267-8101 au cas le moteur de porte doit être ajusté.
Tensioned Advantage Deluxe Electrol Installation ® ® 7 1/4" 7 1/4" Case Length Variable Position Mounting Brackets 7 5/8" Flat Bracket Mounting Method 9 1/4" Motor End Electrical Junction Box 7 5/8" (Suggested) 3/8" Threaded Rod (Not Included) Attached to 7 1/4"...
Page 7
Tensioned Advantage Deluxe Electrol Instructions For Standard Control ® ® 120V Wiring Diagram NOTE: 20-24AWG Wire Recommended NOTE: Electrical connections on For Connecting Wall Switch to the Dual left end of case. Motor Controller Use provided knockouts for all Front of Back of Wall Wall...
Page 8
Tensioned Advantage Deluxe Electrol Instructions Optional SCB-100 Control ® ® 120V Wiring Diagram NOTE: Electrical connections on RJ-14 to DB-9 left end of case. Connector Use provided knockouts for all To Third Party electrical connections. DO NOT Control System drill additional holes into screen 6P4C RJ-14 case or end cap.
Page 9
Tensioned Advantage Deluxe Electrol Instructions Optional SCB-100 Control (continued) ® ® 220V Wiring Diagram NOTE: Electrical connections on RJ-14 to DB-9 left end of case. Connector Use provided knockouts for all To Third Party electrical connections. DO NOT Control System drill additional holes into screen 6P4C RJ-14...
Troubleshooting Symptom Cause Solution Verify 115-125V (or 220-240V). If insufficient voltage, If screen is not responding Incorrect line voltage. rewire incoming electric line. properly and SCB100 or SCB200 controls are used, Blown facility fuse. Replace facility fuse. contact the factory for troubleshooting assistance.
Page 11
Troubleshooting (continued) Symptom Cause Solution Hinge is bound or has a foreign substance on it Check installation to free door. Clear any foreign which does not allow it to open by gravity. substance; i.e., paint or plaster from hinge. Door will not open. No power.
Page 12
Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
Need help?
Do you have a question about the Tensioned Advantage Deluxe Electrol and is the answer not in the manual?
Questions and answers