Da-Lite Tensioned Advantage Deluxe Electrol Instruction Book page 4

Screen And Roller Assembly Installation
If your screen was shipped with the motor and roller already installed proceed to step 6.
1. Remove the screw from each end of the access door (front
door) and open the door. See figure 1.
2. Carefully unpack screen and roller assembly. Leave packing
paper on the roller.
3. Place the roller assembly into the case with the motor on the
left side. The limit switches should be facing down. Line up
the square pin on the motor with the square hole in the
bracket. Secure with cotter pin. See figure 2.
4. Lift the pin end (right end) of the roller into position and slide
the bracket onto the roller pin. Tighten two nuts to secure the
bracket. Secure pin end with cotter pin. See figure 3.
5. Complete electrical hook-up by snapping motor wire
connector into case connector.
6. Remove shipping brackets by removing the hex head screws
from aluminum slat and case. Slat should move freely. See
figure 2. (Only if the roller assembly is preinstalled.)
Screen Motor
Adjustment
Knob "Down"
Cotter Pin
Adjustment
Knob "Up"
Door
Microswitch
Door Motor
Hex Head Screws
4
Shipping
Bracket
Figure 2
7. Test installation by operating the screen several times. Be
prepared to stop the screen. Standard Duty Cycle: 1 MIN. ON/3
MIN. OFF. The fabric door (rear door) will not close until the
wall switch is placed in the up position and when the screen
motor stops at its limit switch in the up direction.
CAUTION: Excessive continuous operation may cause the
motor to overheat. If this happens the motor will shut off
until it cools to a normal operating temperature.
ATTENTION! Le fonctionnement continu et excessif peut
provoquer une surchauffe.Si cela se produit, les moteurs
s'arrêteront jusqu'à qu'ils se soient refroidis à la
température normale de fonctionnement.
8. Remove any shipping foam attached to the inside of the
access and fabric doors before operation.
9. Run the screen down enough to open the fabric door. Close
the access door and reinstall the screws to secure the door.
Fabric
Door
Cotter Pin
Access Door
Pin End
Figure 3