Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Da-Lite Manuals
  4. Projector Accessories
  5. Tensioned Cosmopolitan Series
  6. Instruction manual

Da-Lite Tensioned Cosmopolitan Series Instruction Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
INSTRUCTION MANUALS
Tensioned Cosmopolitan
Series
®

Advertisement

loading

Related Manuals for Da-Lite Tensioned Cosmopolitan Series

Summary of Contents for Da-Lite Tensioned Cosmopolitan Series

  • Page 1 INSTRUCTION MANUALS Tensioned Cosmopolitan Series ®...
  • Page 2 Table of Contents Tensioned Cosmopolitan ® Tensioned Cosmopolitan (over 12' W) ®...
  • Page 3 INSTRUCTION MANUAL Tensioned Cosmopolitan...

  • Page 4: Important Safety Instructions

    It is the installer’s responsibility to make sure the order to avoid hazard. structure to which this component is attached can support the 7. Supplied drive is only intended for use in Da-Lite screen models weight of all equipment. Reinforce the structure as required Advantage, Contour, and Cosmopolitan.

  • Page 5: Installation

    Installation Motor Overall Length of Case Between Hanger Eyes 3/4" Diameter Hole For Wall Installation Overall Length of Slat 4 5/8" 13/32" 1 7/8" 3/8" Diameter For Ceiling Mounting 5 7/8" Enclosure Cover 7/8" Diameter Opening For Electrical Settings Picture Surface Slat...
  • Page 6 Installation (continued) NOTE: Under no circumstances should unit be completely sealed in recessed installation. Allow access for service. Picture surface is centered in case. Case extends 5-1/2" beyond surface on either end. Do not attach anything to screen slat rod or bottom fabric pocket. Make sure screen is level.
  • Page 7 Installation (continued) Screen may be mounted on a wall, suspended from ceiling or For Ceiling For Wall extension brackets. Wall screens must be mounted level and with the case-back parallel to the wall. Wall Mounting Select fasteners of proper type for wall or ceiling involved. 2.
  • Page 8 120V Wiring Diagram For Screens Without A Built-In Low Voltage Control Wiring Enclosure Cover To Junction Box, Mounted In Screen Case, In Which Internal Wiring Terminates In White, Black and Red Leads Down White Limit Switch Adjustment Black Rocker Switch White Operating Switch Black With...
  • Page 9 120V Wiring Diagram with Optional Built-In Low Voltage Control Wall Switch 120V Wiring Diagram IMPORTANT NOTE: The wall switch is REQUIRED to make any limit switch RJ-45 Input adjustments, EVEN if a third party control system is used. Therefore, it is advised to locate the wall switch in an Junction Box Cat5e or Cat6 Cable...
  • Page 10 230V Wiring Diagram For Screens Without A Built-In Low Voltage Control - Rocker Switch NOTE: A single switch cannot be used to operate more than one screen. In multiple control installations this switch is replaced by the low voltage control, operated from push button stations. Contact the factory for further information. Black (Up) To Junction Box, Mounted In Screen Case, Brown (Down)
  • Page 11 230V Wiring Diagram with Optional Built-In Low Voltage Control Wall Switch 230V Wiring Diagram IMPORTANT NOTE: The wall switch is REQUIRED to make any limit switch RJ-45 Input adjustments, EVEN if a third party control system is used. Therefore, it is advised to locate the wall switch in an Cat5e or Cat6 Cable Junction Box...
  • Page 12 220V Wiring Diagram with Optional Built-In Low Voltage Control (continued) 230V Wiring Diagram with Opitonal European Style Wall IMPORTANT NOTE: The European style wall switch is for Switch operation only and CANNOT be used to make limit switch adjustments. Therefore, it is advised to locate the limit Use 3-conductor 20–24 gauge wire to connect European style adjustment wall switch in an accessible location.

  • Page 13: Screen Adjustment

    Screen Adjustment Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust for more or less picture drop (viewing area), proceed in the following manner:...
  • Page 14 Screen Adjustment (continued) For Screens With A Built-In Low Voltage Control and use the up button on front of switch. Press and hold until 1. Locate the wall switch and remove the cover plate from the desired travel position is reached. If you travel to far up the 3-button wall switch and remove the switch from the you can press the down to move the screen downward.
  • Page 15 Operation of Screens With A Built-In Low Voltage Control Operation & Limit Adjustment Wall Switch “Up” Button Press “DOWN” button on screen switch and screen will deploy out of case in downward direction. “Stop” Button 2. Press “STOP” button on screen switch and screen will stop if in movement.

  • Page 16: Troubleshooting

    Capacitor burned out. Replace motor assembly. Incorrect stopping position in “Down” limit switch out of adjustment. Contact Da-Lite at 800-622-3737 or 574-267-8101. downward direction. Incorrect stopping position in “Up” limit switch out of adjustment. Contact Da-Lite at 800-622-3737 or 574-267-8101.
  • Page 17 Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
  • Page 18 P +852 2145 4099 E av.asia.sales@legrand.com COMMERCIAL BRANDS © 2023 Legrand AV Inc. 200058 (REV 3) 12/23 Da-Lite is a registered trademark of Legrand AV Inc. All other brand names or marks are used for identification purposes and are trademarks of their respective owners.
  • Page 19 INSTRUCTION MANUAL Tensioned Cosmopolitan ® (over 12' W)
  • Page 20 Legrand AV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. Da-Lite® is a registered trademark of Legrand AV Inc. All rights reserved. Important Safety Instructions When using your video equipment, basic safety precautions should always be followed, including the following: Read and understand all instructions before using.
  • Page 21 Installation The Tensioned Cosmopolitan® (over 12' W) comes with brackets to allow for wall mount or ceiling mount installations. Procedures for each method are as follows:: Wall Mount 1. Remove the four ceiling mount brackets from the wall mount bracket. 2.
  • Page 22 120V Wiring Diagram For Screens Without A Built-In Low Voltage Control Internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box located on the left end of the screen case. See wiring diagram below for wire connections.
  • Page 23 120V Wiring Diagram with Optional Built-In Low Voltage Control Wall Switch 120V Wiring Diagram IMPORTANT NOTE: The wall switch is REQUIRED to make any limit switch RJ-45 Input adjustments, EVEN if a third party control system is used. Therefore, it is advised to locate the wall switch in an Cat5e or Cat6 Cable Junction Box...
  • Page 24 230V Wiring Diagram - European Switch NOTE: A single switch cannot be used to operate more than one screen. In multiple control installations this switch is replaced by the low voltage control, operated from push button stations. Contact the factory for further information. Black (Up) To Junction Box, Mounted In Screen Case, Brown (Down)
  • Page 25 230V Wiring Diagram with Optional Built-In Low Voltage Control Wall Switch 230V Wiring Diagram IMPORTANT NOTE: The wall switch is REQUIRED to make any limit switch RJ-45 Input adjustments, EVEN if a third party control system is used. Therefore, it is advised to locate the wall switch in an Junction Box Cat5e or Cat6 Cable...
  • Page 26 230V Wiring Diagram with Optional Built-In Low Voltage Control (Cont.) IMPORTANT NOTE: The European style wall switch is for 230V Wiring Diagram with Opitonal European Style Wall Switch operation only and CANNOT be used to make limit switch adjustments. Therefore, it is advised to locate the limit Use 3-conductor 20–24 gauge wire to connect European style adjustment wall switch in an accessible location.
  • Page 27 Screen Adjustment For Screens Without A Built-In Low Voltage Control Screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory. No further adjustment is necessary. If you need to make minor stop position adjustments see the appropriate step below. SETTING THE DOWN LIMIT POSITION CAUTION: Adjusting the down limit switch for less drop by more than 6”...
  • Page 28 Screen Adjustment with Optional Built-In Low Voltage Control Locate the wall switch and remove the cover plate from the To adjust the up limit switch, press and hold the up tactile wall switch and remove the switch from the junction box. button until the LED on the back of the switch turns solid green.
  • Page 29 Lost roller wrap. See instructions below. Incorrect stopping position in downward direction. “Down” limit switch out of adjustment. Contact Da-Lite at 800-622-3737 or 574-267-8101. Lost roller wrap. See instructions below. Incorrect stopping position in upward direction. “Up” limit switch out of adjustment.
  • Page 30 Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
  • Page 31 P +852 2145 4099 E av.asia.sales@legrand.com COMMERCIAL BRANDS © 2023 Legrand AV Inc. 200057 12/23 (REV 1) Da-Lite is a registered trademark of Legrand AV Inc. All other brand names or marks are used for identification purposes and are trademarks of their respective owners.