Phone Identity; Further Information - Siemens SXG75 User Manual

Eject card
Eject the RS MultiMediaCard from the
phone safely without losing data
that is still being transmitted to the
card.
C
Press to confirm request.
If card is still busy, confirm the error
C
message with
Memory assistant
Start the memory assistant
(page 21).

Phone identity

The phone identity number (IMEI) is
displayed. This information may be
useful for customer service.
F
Switch between tabs to
display additional infor-
mation about the device.
Device check
After the last information page,
a self-test as well as the individual
test are offered. If you select
all individual tests are carried out.
Software version
To display the software version for your
phone in standby mode:
*
# 0 6 #, and select the Configuration tab.
and try again later.
Self test,
Device manager (DM)
Sessions can be initiated in different
ways.
• Manual session: You start the DM
session via this menu option.
• WAP push: Your service provider
initiates a DM session via WAP
push (page 65). You receive an
Over The Air Provisioning (OTAP)
message. The message is dis-
played. Confirm the request to
start the DM session.
The OTAP message can be protect-
ed and you may need a PIN to
open it. Contact your provider for

further information.

• Software update: The phone
checks the software status each
time it is switched on. If an update
is available a request is displayed.
Confirm the requests to start the
software update and to re-boot
your phone.
Additional information
If you want to start a session the battery
must be charged at least 50%.
The phone default settings vary from
service provider to service provider
and can be as follows:
• The settings have already been
implemented by the provider. You
can start immediately.
Settings 125