M-LOCKS EuroLine Modular Series User Manual

MODULAR
Technical manual
ST2060, ST3060, ST3560
CHARACTERISTICS
The protrusion of this dial assembly from the EuroLine "Modular" series is very low. ST3560
further reduces the protrusion as it is recessed and almost flush with the door surface. The
dial is made from metal with a mat chrome finish. The plastic base unit is available in mat
chrome (ST2060) or black (ST3060, ST3560). The dial is delivered with a 6mm square shaft
as spindle and is for use with the ML6740 mechanical combination lock only.
PREPARATION
Measure the distance (D) between the mounting surfaces of the dial and the lock (see picture
below). Cut the shaft in one of the eight provided grooves. Use the table below to determine
in which groove to cut. Do not leave more segments on the shaft than necessary. Normally
no de-burring is required.
M-LOCKS BV
Vlijtstraat 40
NL-7005 BN Doetinchem
ST2060
Distance (D)
less than
39 mm 1.5 inch
51 mm 2.0 inch
64 mm 2.5 inch
77 mm 3.0 inch
89 mm 3.5 inch
102 mm 4.0 inch
115 mm 4.5 inch
127 mm 5.0 inch
ver. 1.1 2011 04 21
1 of 2
ST3060 ST3560
Cut groove #
1
2
3
4
5
6
7
8
Tel: +31 (0)314 376 876
Fax: +31 (0)314 376 878
www.m-locks.com