M-LOCKS EuroLine Compact series Technical Manual

Technical manual
KL1560
CHARACTERISTICS
The EuroLine Compact series was specially developed for safes which have two through
holes, 100mm apart. The plastic housing of the EuroLine unit combines a front reading dial
with a large boltwork handle (metal). The set includes a 6mm square shaft for usage with
lock ML6740 as well as an 8x8mm square shaft to drive the boltwork. The pictures show the
most common usage but the unit can be fitted mirrored and also vertical.
PREPARATION
1. Mechanical Dial
Measure the distance (D) between the mounting surfaces of the dial and the lock (see picture
below). Cut the shaft in one of the eight provided grooves. Use the table below to determine
in which groove to cut. Do not leave more segments on the shaft than necessary. Normally
no de-burring is required.
Affix the 6mm shaft with the provided screw in the dial and cover the screw with the small
label. Discard the larger label.
M-LOCKS BV
Vlijtstraat 40
NL-7005 BN Doetinchem
Distance (D)
less than
28 mm 1.1 inch
40 mm 1.6 inch
53 mm 2.1 inch
66 mm 2.6 inch
78 mm 3.1 inch
91 mm 3.6 inch
104 mm 4.1 inch
116 mm 4.6 inch
ver. 1.0 2010 05 26
1
Cut groove #
1
2
3
4
5
6
7
8
Tel: +31 (0)314 376 876
Fax: +31 (0)314 376 878
www.m-locks.com