Display Mode; Adjusting Display Contrast - Baldor 18H Series Installation & Operating Manual

Section 1
General Information

Display Mode

Control Operation

Adjusting Display Contrast

(Contrast may be adjusted in display mode when motor is stopped or running)
Action
Apply Power
Press DISP Key
Press SHIFT SHIFT
Press Y or
Key
Press ENTER
4-2 Programming & Operation
The control is in the DISPLAY MODE at all times except when parameter values are
changed (Programming mode). The Keypad Display shows the status of the control as in
the following example.
Motor Status
The DISPLAY MODE is used to view DIAGNOSTIC INFO and the FAULT LOG. The
description of how to do these tasks are described on the following pages.
When AC power is applied to the control the keypad should display the status of the
control. If there is no visible display, use the following procedure to adjust the contrast of
the display.
Description
No visible display
Places control in display mode
Allows display contrast
adjustment
Adjusts display intensity
Saves level of contrast and exits
to display mode
Output Condition
Value and Units
Display
Typical display
Comments
MN718