Add The Module To A Project - Allen-Bradley Logix5000 User Manual

Add the Module to a Project

Add an EtherNet/IP Communication Module to a
Controller Project
Topic
Add the Module to a Project
Time Synchronization
After you install the communication module and set the IP address, you must add
the module to a controller project. The project must be online to set the Speed
and Duplex configurable parameters on the module.
You must use the Logix Designer application, version 28 or greater, to
IMPORTANT
configure the 5069-AEN2TR EtherNet/IP adapter. Version 28 or greater is
slightly different from previous programming software versions. For example,
in some cases, instead of tabs across the top of the Module Properties dialog
box, the application uses categories on the left side of the dialog box.
1. Verify that your project is offline.
2. Right-click your network port, and choose New Module.
Rockwell Automation Publication ENET-UM004B-EN-P - November 2015
4
Chapter
Page
39
50
39