Operation using a telephone system
Activate the keypad for the next call only
Step
by
All dialling characters (
Step
the next connection is made (dialling and call). When connected, the keypad
*
is retained and the unit does not automatically switch to tone dialling (DTMF).
1.
Press [
2.
(
before menu item = ON / none = OFF).
Special requirements
If you encounter problems when connecting your Gigaset 4110/isdn behind
your ISDN PBX, such as:
- handset does not ring to signal incoming calls, or
- a fault message is displayed
you should consider the following essential requirements:
First requirement:
Each Gigaset terminal (handset) requires a separate send MSN.
1st step
*
Store 1 internal MSN of your PBX for each Gigaset terminal.
1.
Press [
2.
Set up MSN
2nd step
Assign each Gigaset terminal one of the previously stored MSNs as the send
*
MSN (such as "Internal 0" to "Internal 2").
1.
Press [
2.
Setup user
MSN
Second requirement:
It is not possible for several MSNs of the Gigaset to be called simultaneously
from your PBX.
To ensure that the registered handsets can ring at the same time when a call
arrives, first make the following setting:
3rd step
Store another internal MSN of your PBX in your Gigaset 4110isdn. This internal
MSN of your PBX serves as a call group address for Gigaset terminals that can
*
be combined in step 2.
1.
Press [
2.
Set up MSN
84
0
-
9
,
is pressed for menus.
Z
] and [OK ] to select:
is pressed for menus.
Z
] and [OK ] to select:
.
is pressed for menus.
Z
] and [OK ] to select:
→
Setup device
.
is pressed for menus.
Z
] and [OK ] to select:
.
*
,
#
) are sent as a keypad character sequence when
→
Base Settings
Call preparat.
→
Base Settings
Settings
→
Base Settings
Settings
→ Press [
] to open the additional menu →
→
Base Settings
Settings
→
Temp. keypad
→
→
ISDN settings
→
→
System settings
Send
→
→
ISDN settings