System settings
Step
by
step
The abbreviations in brackets after the titles stand for the corresponding ISDN
feature. Some features can only be used if enabled by the provider (additional
charge).
Changing the names for internal subscribers
With the factory default, the names
ternal numbers in accordance with their numbering. These entries may be
*
changed to suit your requirements.
is pressed for menus.
1.
Press [
2.
device
Change the name and select [
3.
Press [
4.
The name is now displayed in the internal list and also when an internal call is
made from this internal no.
Call waiting - activating/deactivating CW
This feature can be set up separately for each user. When call waiting is acti-
vated, the caller hears the on-hook signal if you are already conducting a call.
If call waiting is deactivated, the caller hears the ring tone if you are
already conducting a call and additional devices are assigned to this MSN.
If call waiting is deactivated, the caller hears the busy signal if you are already
conducting a call, and are either the only user assigned this MSN, or if the fea-
ture Busy signal when MSN is engaged (Busy on Busy) see page 32 has been
activated.
Press
1.
Select using [
2.
device
Z
] and [OK ] to select:
→ (required internal no.) → [
Z
] and [OK ] to select:
*
for selection menus.
Z
] and [OK ]:
Base Settings
→ (required internal user) → [
Int.11
,
Int.12
etc. are allocated to all the in-
→
Base Settings
Settings
] →
Name
.
] to confirm.
Save entry
.
→
Settings
] →
Call waiting
System settings
→
→
Setup user
Setup
→
→
Setup user
Setup
31