Siemens Gigaset 4110 Comfort Operating Instructions Manual page 89

Appendix
Question
There is no display of
units/costs.
There is no display of
call costs.
I can't hear anything.
The caller's number is
not displayed.
No numbers can be
dialled.
No calls are being
received.
The forwarding condi-
tions are not displayed
for call forwarding.
The phone also rings
when there are fax/PC
calls.
No call charges are dis-
played.
For PABXs:
There is no connection or
a wrong connection after
dialling a call number.
88
Possible cause
No charge rate informa-
tion supplied.
Cost
per unit = 0.
The key has been
pressed – the micro-
phone has been
"muted. "
Call number transmis-
sion has been barred.
The long-distance code
has changed.
The phone has been
locked.
"Permanent" call for-
warding has been acti-
vated.
The MSN has not been
assigned to the internal
user.
The "internal" class-of-
service has been set.
Internal forwarding has
been activated.
The call number is in the
base phone's call num-
ber list.
Call charge display has
not been activated or this
feature has not been en-
abled by your provider.
The access code has not
be entered or has been
entered incorrectly.
Possible solution
Apply to the phone
company to have meter-
ing pulses transmitted.
Set cost per unit
œ
(page 67).
Press to resume
your conversation.
The caller must apply
to his/her provider to
enable transmission of
the number.
Check and correct the
long-distance code
(page 33).
Check the status dis-
plays, unlock the phone if
necessary (page 15).
Deactivate "perma-
nent" call forwarding
(page 55).
Specify the receive MSN
(page 27).
Change the class-of-ser-
vice (page 79).
Activate "external" for-
warding (page 54).
Apply to your provider to
enable this.
Delete the relevant call
number (MSN) from the
list (page 24).
Activate call charge dis-
play (page 67).
Apply to your provider to
enable the "Charge
transmission" feature.
Check and correct the
access code (page 82).