Battery Charging - UTStarcom UTS 700 U User Manual

700 U (C) User Manual
1.6

Battery Charging

1. Connect the charger plug to the charging jack on the bottom of the handset.
2. Plug the charger into the (100V ~ 240V AC) wall outlet and the battery icon will start
3. Battery is fully charged when the battery icon stops flashing.
4. Disconnect the charger from the AC outlet and the phone.
Note:
Before using the phone for the first time, charge the battery for a minimum of four
hours.
When the LCD displays
When the battery is running out of power and only 20 seconds of talk time remains, a
warning tone ("bi-bi-") is heard and the battery icon flashes. When there is no more
power in the battery the phone switches off automatically.
When the power level of the battery reaches 3% of its capacity in standby mode, a
warning tone ("bi-bi-bi-bi") is heard and the battery icon flashes.
In order to maintain good operating times, fully discharge the battery from time to
time by leaving the phone switched on until it turns itself off.
The phone can be used to make and receive calls while charging if the phone is on.
AC Wall Outlet
to flash.
If the input voltage to the charger is not within the range of 100V ~ 240V AC
±10%, the battery icon on the LCD might flash even when charging is completed
, the phone should be recharged.
Before Using Your Phone 1-9