Install/Remove Battery; Charging Your Battery - UTStarcom TXT8010 User Manual

No Service: Phone cannot receive a signal from the system.
GPS Icon:
Location Service of your phone is disabled/enabled.
Voice Privacy: Indicates Voice Privacy mode.
SSL (Secured Socket Layer): Indicating that secure communication
between client and server has been established during data
communication using encryption.
TTY: TTY mode is active.
Bluetooth:
Indicates Bluetooth mode.
Bluetooth Active: Indicates Bluetooth Active mode.
Bluetooth Conn: Indicates Bluetooth Connect.
BGM: BGM mode is active.
10 10 Chapter 1 − Before Using TXT8010
Battery: Battery charging level — the more blocks, the stronger
the charge.
Keylock: Indicates phone is locked.
New Message: Indicates you have new message.
Voicemail: Indicates you have voicemail messages.
Missed Calls: Indicates you have missed calls.
Calendar Appointment:
Event Alarm is active.
Speaker Phone: Phone is in Speaker Phone mode.
Alarm: Appears when an alarm is set.
All Sounds Off: Ringer volume is set to off.
Alarm Only: Phone will alert you with an alarm tone.
Vibrate Only: Phone will vibrate when call is received.
AVR Active: AVR mode is active.
AVR Listening: Indicates AVR listening.

INSTALL/REMOVE BATTERY

1. Remove the battery cover from the unit.
2. Slide the battery into the slot located at the
bottom of the unit and press until you hear the
"click".
3. To remove the battery, push down on the top of
the battery and slide it out.
4. Slide the battery cover back into the unit.
If the battery is not correctly placed in the compartment, the handset will not turn on
and/or the battery may detach during use.

CHARGING YOUR BATTERY

1. To charge open the protective cover
on the Right Side and connect the
charger adapter. Plug the other end
into a standard outlet.
Before Using TXT8010 − Chapter 1 11