Entering An Ip Card Number And Password - UTStarcom UTS 700 U User Manual

700 U (C) User Manual

4.8 Entering an IP Card Number and Password

This function allows you to enter an IP/200/300 card number and password
in the memory of the phone, which can be dialed via the
1. Press
number and password on the LCD of the phone.
2. Press to enter the edit mode. If no IP card number and
password have been entered then "Enter IP" will be displayed
on the LCD.
3. Press key
number and Password (Maximum of 24 digits).
To delete digits use one of the following methods. Press
to delete the last digit. Press and hold down
two seconds to delete all displayed digits
To cancel and exit, press
screen.
4. To save the IP card number and password, press the
The phone sounds a beep and the new IP card number and
password is displayed.
5. To exit and return to standby mode press
Note:
The settings of IP card number and password may be different
due to different service terminals. Therefore, the card number
and password must be set accordingly.
If is needed by the service network, press
and then to display the current IP card
to on the dial pad to enter the IP card
Other Essential Functions 4-9
key
to return to the previous
key.
.
to input.
for