Eaton Bussmann Series Installation Manual page 7

CCP2-H4X-_ selector and pistol handles for 8 mm shafts
Right side clockwise handle
operation and installation
The following applies to all clockwise
operating selector and pistol switch
handles. Illustrations are of the selector
handle, but apply equally to pistol handle
versions.
Procedures for clockwise handle
catalog numbers:
CCP2-H4X-B1 (selector)
•
CCP2-H4X-R1 (selector)
•
CCP2-H4X-B2 (pistol)
•
CCP2-H4X-R2 (pistol)
•
For installation with switch catalog
numbers:
CCP2S-(pole)-30CC
•
CCP2S-(pole)-30M
•
CCP2S-(pole)-30CF
•
CCP2S-(pole)-60CF
•
CCP2S-(pole)-100CF
•
CCD2S-(pole)-30
•
CCD2S-(pole)-60
•
CCD2S-(pole)-100
•
And either shaft catalog numbers:
CCP2-SH1-290
•
CCP2-SH1-490
•
Switch operating modes
NOTE: Side installation
(handle mounted on the
enclosure's side and not
the door) does NOT provide
for an interlock means to
prevent opening the door
while the switch is in either
the ON or OFF position.
If preventing access to
the enclosure's interior is
desired or required by the
application, use a locking
door latch or install a suitable
hasp to accept a lock.
Handle lock ON operation
Note: NOT to be utilized when switch is applied as a means for emergency stop.
ON
OFF
OFF
2 mm Allen wrench (selector handles) 2.5 mm Allen wrench (pistol handles) 3 N•m (27 lb-in)
To enable the handle's lock ON feature:
Use a 2 mm (selector handle) or 2.5 mm (pistol handle) Allen wrench to loosen the setscrew
•
and remove the handle from the handle base as shown.
Using needle nose pliers, break off the retaining stop on the switch handle bezel as shown.
•
Place handle back onto the handle base and tighten the setscrew.
•
OFF
Installation manual 3A3695
OFF
ON
OFF
ON
ON
Eaton.com/bussmannseries
Effective April 2018
Break out this
portion of
ON
the bezel
OFF
7