Eaton Bussmann Series Installation Manual page 10

Installation manual 3A3695
Effective April 2018
Left side counterclockwise
handle operation and
installation
The following applies to all
counterclockwise operating selector and
pistol switch handles. Illustrations are of
the selector handle, but apply equally to
pistol handle versions.
Procedures for clockwise handle
catalog numbers:
CCP2-H4X-B1L (selector)
•
CCP2-H4X-R1L (selector)
•
CCP2-H4X-B2L (pistol)
•
CCP2-H4X-R2L (pistol)
•
For installation with switch catalog
numbers:
CCP2SL-(pole)-30CC
•
CCP2SL-(pole)-30M
•
CCP2SL-(pole)-30CF
•
CCP2SL-(pole)-60CF
•
CCP2SL-(pole)-100CF
•
CCD2SL-(pole)-30
•
CCD2SL-(pole)-60
•
CCD2SL-(pole)-100
•
And either shaft catalog numbers:
CCP2-SH1-290
•
CCP2-SH1-490
•
10
Eaton.com/bussmannseries
CCP2-H4X-_ selector and pistol handles for 8 mm shafts
Switch operating modes
NOTE: Side installation
(handle mounted on the
enclosure's side and not
the door) does NOT provide
for an interlock means to
prevent opening the door
while the switch is in either
the ON or OFF position.
If preventing access to
the enclosure's interior is
desired or required by the
application, use a locking
door latch or install a suitable
hasp to accept a lock.
Handle lock ON and OFF operation
Note: Lock "ON" NOT to be utilized when switch is applied as a means for emergency stop.
OFF
The counterclockwise rotating handles are factory configured for both lock ON and lock OFF .
To lock the switch, simply rotate the handle to the desired switch state (ON or OFF), depress the
switch locking mechanism and insert up to three 1/4" locks.
OFF
ON
OFF
ON