Table of Contents
Advertisement
Initial Terminal Imaging
Chapter 5:
Introduction
Factory default HDD/SSD images for the RealPOS
auto-imaging USB Flash Drive media. The following procedures describe how to
apply/restore an image on the terminal.
Warning:
created using the Disk Image Backup and Recovery Tool.
Note:
Imaging Procedure
1. Connect the USB flash drive to the target terminal that you wish to image.
2. Connect a USB keyboard to the terminal.
3. Power on the terminal and boot from the USB Flash Drive. This can be done by
4. The system boots in the Windows PE OS environment. Press
5. When the imaging process is complete, enter
6. After the reboot, remove the USB Flash Drive and disconnect the keyboard.
Using this procedure will replace any previously stored OS images
A USB Keyboard is required to perform this operation.
pressing
F8
during the boot and choosing the USB option (NCR), or by entering
BIOS Setup and changing the boot order.
the confirmation prompt to re-image the terminal.
system.
POS are distributed on bootable
XR7
Y
on the keyboard at
Exit
on the keyboard to reboot the
Hide quick links:
Advertisement
Table of Contents
