Hardware Installation
1. Locate the Display Mount within 4 meters (13 ft.) of the host terminal.
2. Determine if the cable should be routed down through the mounting surface or if it
3. If you are installing with a post greater than 215 mm (8.5 in.) secure the Base Plate
4. Connect the Interface Cable to the Display Module, either RS-232 or USB.
should be run on top of the surface. Drill a hole if necessary.
with screws (4) that are appropriate for the surface that you are installing the Base
Plate to.
RS-232 Connector
2-59
22930
USB Connector
31174