Table of Contents
Advertisement
5.
Periodically check the Polisher/Sander
for any potential disc wear. Replace
used disc when necessary.
polishing operating instructions
1.
Set the compressor to 90 PSI, attach a
polishing bonnet (sold separately) and
apply a small amount of the appropriate
polishing compound onto the bonnet in a
circular (or swirl) fashion.
2.
Grip Polisher/Sander with both hands.
3.
Place the Polisher/Sander onto the area
you wish to polish.
4.
Squeeze Throttle Lever (7) halfway
down. Move Polisher/Sander in random
pattern. caution! Do not polish in one
position for more than a few seconds.
5.
Once you've covered the desire area,
stop and replace bonnet with a new
bonnet for buffing operation.
6.
Avoid polishing body part edges. Use
hand force to prevent possible damage
to auto body finish.
7.
Buff the polished area using the same
technique, applying light pressure and
moving in a random pattern until all of
the compound has been removed.
8.
Use a clean, lint-free cloth to remove any
compound from crevices that could not
be reached with Polisher/Sander.
9.
If the tool requires more force to
accomplish the task, verify that the
tool receives sufficient, unobstructed
airflow (CFM) and increase the pressure
(PSI) output of the regulator up to the
maximum air pressure rating of this tool.
10. caution! to preVent tool and
accessorY Failure, resulting
in injurY: do not exceed tool's
maximum air pressure rating.
SKU 4495
For technical questions, please call 1-800-444-3353.
11. If tool still does not have sufficient force
at maximum pressure and sufficient
airflow, a larger tool may be required.
12. To prevent accidents, turn off the tool,
detach the air supply, safely discharge
any residual air pressure in the tool,
and release the throttle and/or turn the
switch to its off position after use. Clean
external surfaces of the tool with clean,
dry cloth, and apply a thin coat of tool
oil. Then store the tool indoors out of
children's reach.
user-Maintenance
instructions
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FroM accidental
operation: turn off tool,
detach air supply, safely
discharge any residual air
pressure in tool, and release
throttle lever before performing
any inspection, maintenance, or
cleaning procedures.
to preVent serious injurY
FroM tool Failure: do not
use damaged equipment. if
abnormal noise, vibration, or
leaking air occurs, have problem
corrected before further use.
to preVent explosion:
lubricate the tool only with
specified lubricants. Lubricate
the air inlet using only pneumatic
tool oil. lubricate the internal
mechanism using only white
lithium grease. other lubricants
to preVent
serious injurY
Page 12
Advertisement
Table of Contents
