Table of Contents
Advertisement
uSer-maintenance
inStructiOnS
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FrOm accidental
OperatiOn:
release the paddle (9) of the
Sander, detach the air supply,
and safely discharge any
residual air pressure in the
Sander before performing any
inspection, maintenance, or
cleaning procedures.
tO preVent SeriOuS
injury FrOm tOOl
Failure:
do not use damaged
equipment. if abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
tO preVent explOSiOn:
lubricate the tool only
with specified lubricants.
lubricate the air inlet
using only pneumatic tool
oil. lubricate the internal
mechanism using only
white lithium grease. Other
lubricants may damage the
mechanism and may be
highly flammable, causing an
explosion.
SKU 66881
tO preVent
SeriOuS injury
For technical questions, please call 1-800-444-3353.
cleaning, maintenance, and
lubrication
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
1.
daily - air Supply maintenance:
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers' instructions.
The lubricator's oil level needs to be
maintained and the moisture filter
must be regularly drained. Performing
routine maintenance on the air supply
will allow the Sander to operate more
safely and will also reduce wear on
the Sander.
2.
beFOre eacH uSe, inspect the
general condition of the Sander.
Check for loose parts, misalignment
or binding of moving parts, cracked
or broken parts, damaged hose, and
any other condition that may affect its
safe operation.
3.
daily, check the Strainer (35) in
the Anchor (33) for excess dirt and
debris. If necessary, clean Strainer.
(See assy. diagram.)
Page 12
Advertisement
Table of Contents
