Assembly Instructions - Central Pneumatic 95030 Set Up And Operating Instructions Manual

1. Prior to use, the Polisher requires the attachment of a 1/4" - 18 NPT Quick Con-
nector (not included) to its Inlet Bushing (13). To do so, make sure the screen
Air Filter is properly seated in the Inlet Bushing. Wrap approximately 3" of pipe
thread sealer tape (not included) around the male threads of the Quick Connec-
tor. Then, firmly tighten the Quick Connector into the Inlet Bushing.
(See Figure B.)
FOAM PAd (31) OR BUFFINg PAd (32)
OPEN ENd WRENCH
FIgURE C
2. Use the accessory Open End Wrench (30) to hold the Planet Gear Seat (22) in
place. Then, firmly hand screw the 3" Pad (29) onto the Clamp Nut.
(See Figure C.)
3. If applying a
onto the 3" Pad (29). If buffing the workpiece, install the Buffing Pad (32) onto
the 3" Pad. (See Figure C.)
SKU 95030 For technical questions, please call 1-800-444-3353.

ASSEMBLY INSTRUCTIONS

INLET BUSHINg
(13)
(30)
TRIggER
(8)
polish (not included) to the workpiece, install the Foam Pad (31)
FIgURE B
3" PAd
(29)
QUICK CONNECTOR
(NOT INCLUdEd)
REgULATOR
(14)
AIR SUPPLY HOSE
(NOT INCLUdEd)
REV 06j
PAGE 5