Setup Instructions - Central Pneumatic 97055 Set Up And Operating Instructions Manual

read the entire iMportant saFetY inForMation section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
warning
note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram near the end of this manual.
1. Prior to using the Sander, the Sander must have a male Quick Connector (not
included) connected to the tool's Air Inlet (50). To do so, wrap about 3" of Pipe
Thread Seal Tape (not included) around the threads of the Quick Connector.
Then firmly screw in the Quick Connector. (see Figure a.)
2. For best tool performance, you should incorporate an in-line water filter,
regulator and oiler as shown in the illustration below. If an oiler is NOT used, it is
recommended that you squirt 3 to 4 drops of pneumatic tool oil (not included) into
the previously installed Quick Connector of the tool before each use.
(see Figure b.)
to
sander
SKU 97055 For technical questions, please call 1-800-444-3353.
set up instructions
risk of accidental starting; resulting in serious personal
injury. disconnect the sander from its compressed air
source before assembling or making any adjustments to the
tool.
assembly
Figure a
Figure b
regulator
oiler Filter
QuicK
connector
(not included)
air
coMpressor
Page 7