Table of Contents
Advertisement
to its off position to prevent accidental
operation.
note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion after
disconnecting to ensure that the tool is
disconnected and unpowered.
operating instructions
read the entire iMportant
saFetY inForMation
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
inspect tool before use, looking
for damaged, loose, and missing
parts. if any problems are found,
do not use tool until repaired.
tool set up
FroM accidental
operation:
turn off the tool, detach the air
supply, safely discharge any
residual air pressure in the tool,
and release the throttle before
performing any inspection,
maintenance, or cleaning
procedures.
to preVent serious injurY:
do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. improper
adjustment can result in tool
failure or other serious hazards.
SKU 4495
to preVent
serious injurY
For technical questions, please call 1-800-444-3353.
Work piece and Work area set up
1.
Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2.
Route the air hose along a safe path to
reach the work area without creating a
tripping hazard or exposing the air hose
to possible damage. The air hose must
be long enough to reach the work area
with enough extra length to allow free
movement while working.
3.
Secure loose workpieces using a vise
or clamps (not included) to prevent
movement while working.
4.
There must not be hazardous objects
(such as utility lines or foreign objects)
nearby that will present a hazard while
working.
5.
If an automatic oiler is not used, put a
few drops of Pneumatic Tool Oil into tool
at air inlet connection before use. Add
a few drops more after each hour of
continual use.
sanding operating instructions
1.
Set the compressor to 90 PSI, locate
the Pad in the center of the sanding disc
(sold separately), making sure there is
equal overhang on the disc.
2.
Grip Polisher/Sander with both hands
and place onto the area to sand.
3.
Squeeze the Throttle Lever (7). You can
vary the speed of the Polisher/Sander to
suit your needs by varying the amount of
pressure on the Throttle Lever.
4.
Move Polisher/Sander in a uniform
pattern, either up or down or side to side.
This will ensure even sanding.
Page 11
Advertisement
Table of Contents
