Table of Contents
Advertisement
10.
When finished sanding, release the
Air Valve Lever (28) and allow the Air
Reciprocating Sander to slow to a
stop completely before laying the tool
down.
11.
Disconnect air supply hose, put a few
drops of pneumatic tools lubricating
oil in the air inlet of the tool. Connect
the air supply hose. Run the tool for
a few seconds only.
12.
Disconnect the air hose from the Air
Regulator Assembly (30).
13.
Wipe off the Air Reciprocating Sander
with a clean, soft cloth before stor-
ing the tool inside, out of the reach of
children.
user-MAintenAnce
instructions
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FroM AccidentAl
operAtion:
turn off the tool, detach the
air supply, safely discharge
any residual air pressure in
the tool, and release the
throttle and/or turn the switch
to its off position before
performing any inspection,
maintenance, or cleaning
procedures.
SKU 98189
to preVent
serious injurY
For technical questions, please call 1-800-444-3353.
to preVent serious
injurY FroM tool
FAilure: do not use
damaged equipment. if
abnormal noise, vibration,
or leaking air occurs, have
the problem corrected before
further use.
to preVent explosion:
lubricate the tool only
with specified lubricants.
lubricate the air inlet
using only pneumatic tool
oil. lubricate the internal
mechanism using only
white lithium grease. other
lubricants may damage the
mechanism and may be
highly flammable, causing an
explosion.
cleaning, Maintenance, and
lubrication
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
1.
daily - Air supply Maintenance:
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers' instructions.
The lubricator's oil level needs to be
maintained and the moisture filter
must be regularly drained. Perform-
ing routine maintenance on the air
supply will allow the tool to operate
more safely and will also reduce wear
on the tool. note: Always follow
all Manufacturer's safety warnings
and procedures for the air com-
pressor and components you are
using with this reciprocating Air
reciprocating sander.
Page 10
Advertisement
Table of Contents
