Table of Contents
Advertisement
8.
When you are done working, lift the polishing pad from the work surface, and
release the Throttle Lever (23). The pad will cease to rotate. Repeat this process
with different cleaning or polishing materials (not supplied) as needed. You may
change polishing pads as needed.
9.
When you are done using this tool, turn off the air compressor, and disconnect
the air hose. Put the Angle Polisher away in its proper storage place.
10. Always clean your pads before storing them. Follow the instructions provided by
the polish or cleaner manufacturer for best results.
NOTE: Turn off your air compressor and disconnect the air pressure hose before
changing pads or making any adjustments to this tool. Severe injury or property
damage may otherwise result.
Note: Always wear ANSI approved safety goggles when performing maintenance on
the Air Angle Polisher.
1.
Your Angle Polisher should be kept clean, dry and protected from corrosion or
damage.
2.
When not in use, store your tool in the provided plastic storage case, out of the
reach of children. Do not allow it to be exposed to water, corrosive materials, or
undue banging around.
3.
If you are not using an in-line oiler, you should inject a few drops of pneumatic oil
into the air inlet of the tool after every hour of continuous use.
4.
If your tool loses power, or you notice air leaks, take it to a certified technician
for service.
5.
Servicing of this tool should only be done by a qualified service technician.
SKU 92558
Maintenance
Page 6
Advertisement
Table of Contents
