Table of Contents
Advertisement
Quickstart Instructions
Rack Mount Transmitter
1. Connect to a power outlet using the supplied power adapter.
2. Attach the supplied antennas to the antenna out BNC connectors.
3. Connect the audio source, such as the output of a mixer, to the audio inputs. You can use both input jacks or
choose either one for a mono source.
◦ For mono (one input), access the Audio menu and select Mono.
◦ Set the input sensitivity to match the source by selecting Audio INPUT from the LCD configuration menu:
Aux (-10dBV) or Line (+4dBu).
4. Make sure the RF switch is OFF. Turn the power ON.
5. Adjust the audio source level so that, for the average input signal level, the top two yellow LEDs flicker and the
lower LEDs are solid.
◦ If the red clip LED illuminates, the inputs are overdriven. Decrease the level using the ▼▲ buttons or
change the input sensitivity to +4 dBu.
◦ If the signal level is too low, change the input sensitivity to –10 dBV
Shure Incorporated
5/30
Advertisement
Table of Contents
