Table of Contents
Advertisement
Utilities and Display Settings
Access the following settings from the UTILITIES menu.
UTILITIES
CUEMODE
Enters CUEMODE (to exit, press enter and select EXIT CUEMODE)
DISPLAY
Change the display settings on the bodypack
CONTRAST
Sets display brightness to high, low, or medium.
LOCK PANEL
Locks all controls except power and volume. To unlock, press exit, select OFF, and press enter.
BATTERY
Displays the following: Hrs: Min Left, temperature, Status, Cycle Count, and Health.
RESTORE
Returns receiver to factory default settings.
Multiple System Setup
When setting up multiple systems, designate a single bodypack to scan for available frequencies and download
them to all the rack units.
The bodypack must be from the same frequency band as all the transmitters.
1. Power on all the rack units. Turn off the RF. (This prevents them from interfering with the frequency scan.)
Note: Turn on all other wireless or digital devices as they would be during the performance or presentation (so
the scan will detect and avoid any interferance they generate).
2. Use the bodypack to scan for a group by pressing and holding the scan button for two seconds. The body-
pack displays the group and the number of available channels, and flashes SYNC NOW....
Important: Note the number of available channels. If you have more rack units than available channels, elimi-
nate potential sources of interference and try again, or call Shure Applications for assistance.
3. Sync the bodypack with the first rack unit by aligning the IR windows and pressing sync.
4. Press scan again on the bodypack to find the next available frequency.
5. Sync the bodypack with the next rack unit.
6. Repeat with all the rack units.
7. Sync each performer's bodypack to its respective rack unit by aligning the IR windows and pressing snyc. DO
NOT press scan on the bodypacks.
8. Turn on the RF on all rack units. The systems are ready to use.
Shure Incorporated
18/30
Advertisement
Table of Contents
