The Unit Id Number - Phonetics Sensaphone 4100 User Manual

NOTE: Unauthorized personnel are prevented from changing any of the Model 4100's
programming. However, they are not stopped from using WHAT IS to find out any
information. Additional protection may be necessary.
To unlock the keyboard:
1. Press the WHAT IS key
2. Press the KEY button
The 4100 will say "Enter security code."
3. Using the number keys, enter the digits of the programmed code
The 4100 will recite the digits as they are pressed.
4. Press ENTER
If the correct code is entered, the 4100 will say "OK." If the wrong code is
entered, the 4100 will say "Error two."

THE UNIT ID NUMBER

The Model 4100 unit ID number can be up to 32 digits long. It is usually the telephone
number where the unit is installed. The ID should be programmed AFTER all the sensors
are wired to the unit in their normal state. Programming the ID number establishes the
normal condition of the alert input in the Model 4100's memory.
To program the ID number:
1. Press the SET key
2. Press the ID# key
3. Using the number keys, enter up to 32 digits for the ID number
The 4100 will recite the digits as they are pressed.
4. Press ENTER
The 4100 will say "Enter."
To interrogate:
1. Press the WHAT IS key
2. Press the ID# key
The 4100 will say "This is telephone number," then recite the ID number and provide
a status report. (See Chapter 5, "Status Report," for more information.)
(enter security code)
(enter number)
Chapter 3: Communications Programming
25