Table of Contents
Advertisement
Sensaphone Model 4100 Instruction Manual
STATUS REPORT
The status report feature allows you to call in to the Model 4100 and check the temperature,
alarm and power status. The unit will answer after the programmed rings until answer. If
any alarm conditions exist, the alarm message will be recited. You can also listen in to
on-site sounds.
The following is an example of what the unit will recite during a status report:
Hello
This is telephone number 555-1234 (User-programmed unit phone number)
The time is 12:15 PM (Current time)
Alert condition OK (Alarm status. Other responses: 1 EXISTS, 2 EXISTS, 3 EXISTS, 4
EXISTS)
The temperature is 70 degrees (Current temperature)
OK (Temperature alarm condition. Other responses: The temperature is high/low.)
Two (Says this only if a remote temperature sensor is attached to the AUX TEMP
input.)
The temperature is 70 degrees (Says this only if a remote temperature sensor is
attached to the AUX TEMP input.)
The electricity is ON (Power status. Other response: OFF)
Battery condition OK (Backup battery condition. Other responses: Battery condition
low, replace battery.)
Sound level OK (Sound level status. Other response: HIGH)
NO NUMBER (Says this only if no dialout phone numbers have been programmed.)
Listen to the sound level for 10 seconds (User-programmed listen-in time)
The Model 4100 repeats the status report once more and then hangs up.
Have a good day.
38
Advertisement
Table of Contents
