Chapter 7: Programming Summary; Monitoring Functions - Phonetics Sensaphone 4100 User Manual

After the Model 4100 has been completely installed, you are ready to begin programming
the unit. The following is a recommended sequence for the programming commands. Refer
to the programming chapters 3 and 4 for explanation on how to use each command. This
section is intended to help you understand the commands and organize your programming.

MONITORING FUNCTIONS

1. Disable inputs 1-3, 4 (AUX TEMP). This action will allow you to wire the dry
contact inputs without tripping an alarm dialout.
2. Wire inputs 1-4. See INSTALLATION.
3. Configure inputs as normally opened or normally closed. This command determines
what will be the normal or alarm state for each input 1-4. When you set the ID
number, the present open/closed state of your sensors will be considered normal.
For example, if you have input 1 wired as a closed input, setting the ID number will
make it normally closed. If the input is opened, an alarm will result.
4. Enable inputs 1-4. The inputs are now operational and monitoring chosen conditions.
5. Disable high/low temperature inputs. This will allow you to set limits without
causing an alarm dialout.
6. Set high and low temperature limits. Be careful not to set the temperature limits too
close to normal room temperature to avoid dialouts for minor/temporary changes in
temperature.
7. Enable temperature inputs. The temperature inputs are now operational.
8. Enable or disable AC power monitoring. The Model 4100 is capable of monitoring
AC power failure. This feature is built-in, no external wiring is required. You can
enable or disable the power detection. When enabled, the Model 4100 will dial out for
a power failure. When disabled, the 4100 will not dial out if a power failure occurs.
9. Power recognition time. This is the length of time a power failure must exist before
the 4100 considers it an alarm.
10. Enable or disable high sound level alarm. The Model 4100 monitors sound through
the built-in microphone. When the current sound level suddenly exceeds the normal
sound level, the high sound alarm causes the Model 4100 to dial out. When disabled,
the 4100 will not dial out for high sound.
11. Sensitize/desensitize sound monitoring. This command allows you to make the micro
phone more sensitive or less sensitive to sound at the unit location. This helps to
eliminate false sound alarms if the sound level is normally high.
CHAPTER 7
PROGRAMMING SUMMARY

Chapter 7: Programming Summary

41