Troubleshooting - Piazzetta P962 Instructions For Installation, Use And Maintenance Manual

8.0 TROUBLESHOOTING

Some of the problems indicated below may be resolved by following the instructions. All work must be carried out when the appliance is cold and
disconnected from the electricity supply (pull out the plug). Authorised qualified persons must be contacted, in accordance with current regulations,
whenever it is necessary to work on parts inside the cladding or the firebox in order to resolve the problem.
Unauthorised tampering with the appliance or the use of other than original spare parts invalidates the warranty and relieves the manufacturer
from all liability.
Problems caused by incompetent or insufficient maintenance or by failure to comply with the instructions in the installation and operating booklet
for the product relieve the manufacturer from all and any liability.
PROBLEM
The control panel display is not lit
Stove combustion gas safety device
A A L L F F 1 1
" " stove status
All manuals and user guides at all-guides.com
CAUSE
The appliance is not powered
Faulty power cable
Fuses blown
Faulty control panel
Faulty flat cable
Faulty electronic board
Blocked flue or flue gas outlet
Door open
Broken smoke extractor
Flue system too long
Damaged door sealing gaskets
Hose connection blocked
Silicone piping blocked or broken
Faulty electronic board
DT2011179-00
SOLUTION
Check that the power cable is plugged
into the wall socket and connected to
the appliance
Replace the power cable (use only
original spares)
Check the fuses in both the plug and the
electronic board, replacing them if
necessary. If the problem persists call
an electrician
Replace the control panel (use only
original spares)
Replace the flat cable (use only original
spares)
Replace the electronic board (use only
original spares)
Check and clean the flue and the
outlet
Control if the door is closed
Replace the motor (use only original
spares)
Check correct installation (see section 5)
Check all the gaskets and seals of the
door and flue pipe
Dismantle and clean the
connection for the vacuum gauge
Check and/or replace piping
Replace the electronic board (use only
original spares)
TROUBLESHOOTING
hose
47