Multicomfort - Piazzetta P962 Instructions For Installation, Use And Maintenance Manual

6.9 MULTICOMFORT

The pellet stove is fitted with the Multicomfort function. This works in conjunction with the Multifuoco ventilation system to improve heat distribution.
It allows the room temperature to be read from the stove or from the remote control, so that the Multifuoco settings can be varied according to the
requirements of the rooms to be heated.
If the airflow from your stove has been ducted to other rooms you may read the temperature in the room where the stove is installed or in the room
where the remote control is situated.
Example: your stove is installed in a small room and you are ducting the heat only from the rear of the stove (see solution 1 under the paragraph
"MULTIFUOCO SYSTEM"). You can position the remote control in the room to where the hot air has been ducted and set the required temperature
from this room. To carry out the necessary settings see the Multicomfort menu.
This function is used to choose the sensor for reading the room temperature: from the stove or from the remote control. To make the
most of the Multifuoco fan functions read the paragraphs MULTIFUOCO SYSTEM and MULTICOMFORT OPERATION.
Function
Press the MENU key, then using the SELECT
Select the
M U L T I C O M F O R T
MENU
menu
Confirm by pressing the SET key
Press the SELECT MENU
SELECT RRC to read the room temperature from
Select the Select the
the remote control or SELCT STOVE to read the
REMOTE CONTROL
room temperature from the stove. Confirm by
SENSOR (SELECT
pressing the SET key. After confirmation the
RRC) OR STOVE
readout function enabled (FUNCTION ENGAGED)
(SELCT STOVE)
will appear on the display and the remote control
will automatically return to the initial display.
All manuals and user guides at all-guides.com
MULTICOMFORT
Action
key select the MULTICOMFORT menu.
MENU
SET
ESC
OPT
key and select
MENU
SET
ESC
OPT
Display
!
M U L T I
C O M F O R T
!
S E L E C T
R R C
!
S E L E C T
S T O V E
USE
DT2010251-03
DT2040070-04
37