Use - Piazzetta P962 Instructions For Installation, Use And Maintenance Manual

6.0 USE

• Do not use the stove as a cooking appliance.
• Ensure that the room in which the stove is installed is sufficiently well ventilated (fresh air intake).
• Ensure that all joints in the flue are hermetically sealed using a silicone- (not cement-) based sealant which is resistant to temperatures of up
to 250ºC and which shows no sign of deterioration.
• Check (or have checked) regularly that the flue is clean.
• Under no circumstances use fuels other than pellets.
• Remove any deposits of unused pellets left by failed ignition before restarting the stove.
Keep any inflammable object well away from the stove while it is in use (MINIMUM 80 cm from the front panel).
While in use the door must remain closed and the glass must be present and intact.
The removal of the protective grille inside the pellet hopper is strictly prohibited.
If replenishing with pellets while the stove is lit, ensure that the bag does not come into contact with any hot surfaces.
6.1 LOADING THE PELLETS - Fig. 56 - 57
To load the pellets into the hopper it is advisable to tear off the edge of
the sack and empty the sack directly into the hopper. This makes filling
easier and avoids pouring pellets on top of the stove.
Do not allow sawdust to accumulate on the bottom of the
hopper.
Do leave leftover pellets on top of the stove – they could
catch fire!
Under no circumstances remove the protective grid inside
the hopper.
When refilling with pellets while the appliance is lit, do not
let the pellet sack come into contact with hot surfaces.
6.2 REMOTE CONTROL - Fig. 58
• The pellet stove comes equipped with an LCD-display remote control
and radio transmitter which allow you to operate its various functions.
The remote's range can be affected by other devices which
operate on a continuous radio frequency of 433.92 MHz , for
example radio headphones, toys, wireless mouses etc.
The remote has a range of around seven metres in conditions
where there is no interference from other sources.
• When pressing the keys to select the various functions wait for a
signal from the stove that the selection has registered before
selecting further functions. Or if you are in an adjoining room wait for
confirmation on the remote's display. If the stove is not receiving
signals from the remote try bringing the remote closer to the stove.
Below are listed the various functions of the remote control's keys.
22 USE
All manuals and user guides at all-guides.com
Fig. 56
DT2030459-00
Fig. 58
15
19
18
16
!
2
1 2 3 4 5 6
4
3
5
8
9 MENU
SET
10
DT2010992-00
DT2010035-01
DT2010730-00
Fig. 57
DT2030460-00
DT2010220-05
17
20
13
14
1
7
6
7
11
ESC
OPT
12
DT2030325-00