Table of Contents
Advertisement
B.1
Handling Precautions
The optical characteristics are measured under stable conditions at 25°C (Room
Temperature)
1.
Since the front polarizer is easily damaged, be very careful not to scratch it.
2.
Be sure to turn off the power supply when inserting or disconnecting from the
input connector.
3.
Wipe off water drops immediately. Long contact with water may cause discolor-
ation or spots.
4.
When the panel surface is soiled, wipe it with absorbent cotton or another soft
cloth.
5.
Since the panel is made of glass, it may break or crack if dropped or bumped on
a hard surface.
6.
Since the CMOS LSI is used in this module, be careful of static electricity and
ensure you ground yourself first before handling.
7.
Do not open or modify the module assembly.
8.
Do not press the reflector sheet at the back of the module in any direction.
9.
In case a Module has to be put back into the packing container slot after it has
been taken, please touch the far ends of the LED light bar reflector edge softly,
otherwise the TFT Module may get damaged.
10.
At the insertion or removal of the signal interface connector, be sure not to rotate
nor tilt the Interface Connector on the TFT Module.
11.
After installation of the TFT Module into an enclosure, do not twist nor bend the
TFT Module even momentary. During integration of the enclosure, it should be
taken into consideration that no bending/twisting forces are applied to the TFT
Module from outside. Otherwise the TFT Module may get damaged.
12.
A small amount of materials having no flammability grade are used in the LCD
module. The LCD module should be supplied by power compliant with the
requirements of Limited Power Source (IEC60950 or UL1950), or be applied
exempt thereof.
IDK-1121WP User Manual
28
Advertisement
Table of Contents
